31
EN
3. Connect the exhaust hose (only on models with integrated heater) to the exhaust
hose (see section „Cleaning and Care“) as shown in the illustration.
4. Plug the mains plug into an earthed AC 220 ~ 240 V socket.
5. Press the ON/OFF button to turn on the unit.
Before use
Make sure that the exhaust hose is correctly installed.
Safety instructions for cooling and air dehumidication
• If you are using cooling and dehumidifying functions, wait at least 3 minutes after
turning off the unit before turning it on again.
• Make sure the power supply meets the requirements.
• Use an AC connector.
• Use the AC outlet only for this equipment and make sure that no other equipment is
connected to this circuit.
Cooling
• Press and hold the Mode button until the cooling icon appears on the screen.
• Press TEMP+/TEMP to select the desired temperature (16-31 °C).
• Press the SPEED button to select the fan speed.
Dehumidication
• Press and hold the Mode button until the dehumidication icon appears on the
screen.
• The temperature is automatically set to 2°C less than the room temperature.
• The fan motor speed is automatically set to low.
Fan
• Press and hold the Mode button until the fan icon appears on the screen.
• Press the SPEED button to select the fan speed.
To Next Page
Loading...
Need help?
General
