Klarstein IceWind - Installation; Assembling the Castors; Filling the Water Tank

14
EN
INSTALLATION
Assembling the castors
Put the appliance on a at surface, take out the wrench from foam box, then assemble
the castors.
Note: The back castors are with brake, but the front ones are without (see map 1).
Filling the water tank
• Draw out half of the water tank, then add water (see map 2).
• Pay attention to the level of water tank when add water.(map 3)
• The level of water tank should not over “MAX” scale at any time, when humidifying,
the total level of water tank should not below “MIN” scale.
• Put ice or frozen ice crystal box to the water tank if you want to strengthen the
efciency of cooling. But the total level of water tank should not over “MAX” scale.
1 2 3
brake no brake