EasyManua.ls Logo

Klarstein IGNITO 4 - Page 32

Klarstein IGNITO 4
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
32
EN
• Wipe the  xed parts of the burner cup with a damp cloth and dry afterwards .
• Gently wipe the ignition device and  ame supervision device with a well wrung-out
cloth and wipe dry with a clean cloth.
• Before placing the burners back on the top plate, make sure that the injector is not
blocked.
Re-assemble the Auxiliary, Semi-Rapid, Rapid and Triple-Crown burners as
follows
1. Place the  ame spreader ( 4 ) on to the burner cup ( 5 ) so that the ignition device
and the  ame supervision device extend through their respective holes in the
ame spreader.The  ame spreader must click into place correctly.
2. Position the burner lid ( 1,2,3 ) onto the  ame speader ( 4 ) so that the retaining
pins  t into their respective recesses.
Warning: Danger of  re
Do not mix up the top and bottom.
The locating pins must  t exactly into the notches.