Klarstein MultiChef 4 - Troubleshooting; Gas Burner Troubleshooting; Induction Burner Troubleshooting

53
EN
TROUBLESHOOTING
Gas burner
Problem Check to make sure that:
The burner cannot be lighted or the
ame is not uniform around the
burner.
• The gas holes on the burner are not
clogged;
• All of the movable parts of burners
are xed correctly;
• There is no air ow around the
cooking surface
The ame does not keep lighting to
the burner with thermocouple
• You press the knob all the way;
• You keep pressing the knob
for enough time to activate the
thermocouple.
• The gas holes are not clogged
in the area corresponding to the
thermocouple.
The ame goes out while turning knob
to "Low" setting.
• The gas holes are not clogged.
• There is no air ow around the
cooking surface.
• The minimum has been adjusted
correctly (see the section entitled
"Minimum Regulation").
The cookware is not stable. • The bottom of the cookware is
perfectly at.
• The cookware is centred correctly
on the burner.
• The support grids have not been
inverted.
Induction burner
Problem Check to make sure that:
The cooking zones have become
soiled.
This may be caused by burnt on
remnants of food. This will not
aect the working of the appliance.
However, you should make sure that
the cleaning instructions are being
followed regularly.
The residual heat indicator cannot
work.
If the cooking zone does appear to be
hotter than 60 ℃ and the residual heat
indicator has not come on, contact a
qualied specialist for inspection and
repair.