23
EN
2. Install the tap handle and connect the tap. Make sure that both ends t
together perfectly (see gure 1).
3. Insert the drip tray into the recess provided (see gure 2).
1 2
4. Check if the infrared detection LED (as shown in gure 3) on the top left and
right of the inside of the unit's cooling drum is dirty or damaged. If the beer
keg is not inserted in the cooling keg or is removed, the device cannot operate
normally and the code "OP" is displayed on the control panel.
3
Handle
Tap
Connection for the
beer outlet
Infrared detection LED
To Next Page
Loading...
