Klipsch RSB-11 Firmware Update Instructions

RSB-11 SOUNDBAR FIRMWARE UPDATE INSTRUCTIONS
Copy the “rsb11.hex” file and the “csr11b.ybin” file
to an empty USB flash drive.
The Dolby Digital LED will light up when the MCU
firmware update has started and you can release
the Vol+ key.
Press and hold the Vol+ key on the Soundbar,
then plug in the power cord
(while still holdingthe Vol+ key).
Insert the USB drive into the USB port on the rear
of the Soundbar.
Unplug the power cord from the Soundbar.
Soundbar
3 4
6
5
2
1
HDMI 1 HDMI 2 HDMI 3 TV DIALOG NIGHT
As the update installs - the Virtual Surround Mode
LED will light up, then the Dialog LED, then the
Night Mode LED. All LED’s will turn off when the
update is complete and the unit will power down.
These instructions apply to RSB-11 Soundbars with the Serial
Numbers 1063117164500001 and above

Klipsch RSB-11 Specifications

General

Audio Channels	2
Subwoofer	included
Surround Sound	other
High Resolution Audio	yes
Dialogue Enhancement	no
Number of Drivers	4
Video Pass-through	hdr
HDR Format	dolby vision
Tweeters	2
Maximum Frequency Response	20 kilohertz
Minimum Frequency Response	28 hertz
Inputs	3.5mm audio, hdmi, optical digital audio
Outputs	hdmi
HDMI Inputs	3
HDMI Outputs	1
HDMI ARC Ports	yes
HDMI HDCP 2.2 Inputs	3
HDMI HDCP 2.2 Outputs	1
USB Ports	0
Bluetooth	yes
Wireless Connectivity	bluetooth, wi-fi
Wireless Subwoofer Connectivity	no
Wireless Multi-Room Audio	no
Optical Audio Inputs	1
Remote Control	yes

Weight and Dimensions

Depth	3.25 inches
Height	3.25 inches
Width	44 inches
Net Weight	10 pounds
Subwoofer Depth	16 inches
Subwoofer Height	13.125 inches
Subwoofer Width	7 inches
Subwoofer Weight	24 pounds