Need help?Do you have a question about the Klockner Moeller SUCOS PS 316 and is the answer not in the manual?
Handle modules by the grip/front plate. Switch off PS316 before card insertion/removal. Note coding.
Illustrates configurations for basic units, first and second expander racks, and wiring units.
Warns against mixing BK-BPx.1 and BK-BPx.2 bus coupling units in an assembly.
Instructions for attaching cable clamps after cleaning the surface with a degreasing agent.
Advice on laying 110V/220V AC cables separately from 24V DC cables.
Diagram showing slot assignments for power packs, CPU-22, and peripheral modules.
Details maximum expander racks per basic unit and power filter requirements for more than 2 expanders.
Illustrates two methods (A and B) for bus coupling between expander racks.
Explains coding for Bit-I/O and Parallel bus coupling, including jumper and coding bridge usage.
Prohibits EBE 241.1/243.1 combination; details monitoring functions for EBE 241.1/243.1.
States that only 'active' coding is permitted during parallel bus operation.
Provides detailed dimensions for PS 316, VEH 1, V248, and ES-PS units.
Coding configurations for EBE 261, EBE 200 series, and EBE 253 modules.
Detailed switch settings for module coding within specified range intervals.
Detailed switch settings for module coding within specified range intervals.
Detailed switch settings for module coding within specified range intervals.
Detailed switch settings for module coding within specified range intervals.
General| Input Voltage | 24 V DC |
|---|---|
| Series | SUCOS PS |
| Safety Category | SIL 3, PL e |
| Standards | IEC 61508 |
| Type | Programmable Safety Controller |
To Next Page