Semi-Micro Osmometer K-7400S instructions, V3700
Using the EuroOsmo 7400 Software 34
Command Explanation
Cooling Limit The minimum temperature can be set within the
range from – 18.0 to – 12.0 ° C. Any decimal val-
uewill be rounded in steps of 0.5 ° C.
Units Select the units valid for the measurement
sequence. The choice is mOsmol, ° C, °F, and %.
If °F is selected, the values of the freezing level
and cooling limit are automatically changed to
°F.
By clicking on the <Apply> button, the entered
values are sent to the osmometer. If any value
is out of the allowed range a corresponding
mes sage will be displayed. The setting of the
osmom eter remains unchanged.
Fig. 15: Error message in case of not valid parameters
Fig. 16: Report design area
To Next Page
Loading...
