Switches and Instruments
A Tachometer
This gauge shows the revolutions of the engine and the hours the machine has been used. The
hour meter consists of five digits, with the last digit indicating 1/10th of an hour.
B Temperature Gauge and Fuel Gauge
On the coolant temperature gauge, B indicates temperature .When engine works normally, the
water temperature should be within 80 — 95℃ and the maximum should not be over 98℃
Fuel Gauge
The fuel gauge indicates the amount of fuel in the fuel tank when the key switch is set to ON.
C Engine Oil Pressure Gauge
This gauge shows the pressure of the engine oil. The oil pressure be at 2 — 4 MPa but not lower
than 0.5 MPa while idly running
D Switch
Light Switch D is a two function switch: Pull the indicator switch down to indicate left and push
up to indicate right.
E Switch
Switch E, Press the horn button to sound the horn.
F Switch
This switch a four function switch: push switch to different position for different function: High
and Low beam, Marker lamp, Rear working light.
G Switch
Hazard Warning Light Switch
Push the hazard warning light switch once to operate the hazard warning lights (left and right
turn indicators flash)
Push the hazard warning light switch again to switch off the hazard warning lights
To Next Page
Loading...
