1601 W. DEER VALLEY RD. PHOENIX, AZ 85027 | T. 800-552-5669 | TECHSUPPORT@KNOXBOX.COM | KNOXBOX.COM | PAGE 4
OPE-MVUSER-0473-D
©Knox Company. All rights reserved.
MedVault Retrofit Kit Contents:
QUANTITY DESCRIPTION
1 x Cable Tie
1 x PCA Main Board MedVault 2.5, with battery, coax cable
1 x Label, Alum MedVault 2.5 Serialized
1 x Kapton Tape 0.25"X1"
1 x Screw 6-32 X 0.25"
1 x ESD Wrist strap
1 x Retrofit MedVault 2.5 PCBA Installation instructions
MEDVAULT
®
INSTALLATION GUIDE
Tools Required:
• #2 Phillips Screwdriver for 10/32 and 6/32 screws
• Flat head 3/32 screwdriver
• Fine point wire cutters
• Knox MedVault Tech key
• Safety glasses
• Ground strap (included in kit)
Before You Begin:
• Remove contents and secure by other means if necessary
• Use PIN or Override key to place MedVault in the OPEN state
• Disconnect from power source and remote antenna (if any)
WARNING: Always disconnect power to the MedVault before removing and installing circuit boards.
CAUTION: Wear safety glasses and always use a grounding strap when conducting this installation.
To Next Page
Loading...
Need help?
General
