1601 W. DEER VALLEY RD. PHOENIX, AZ 85027 | T. 800-552-5669 | TECHSUPPORT@KNOXBOX.COM | KNOXBOX.COM | PAGE 5
OPE-MVUSER-0473-D
©Knox Company. All rights reserved.
CIRCUIT BOARD REMOVAL
Step #1 Opening the MedVault
• Use PIN or override key to unlock and open the MedVault door
Step #2 Disconnect power and antenna connection from back panel
• Remove the 2 screws from the service panel on the inside of the door
• Disconnect power first
• Disconnect the coax cable connection for the antenna
MEDVAULT
®
INSTALLATION GUIDE
Screws for back panel of
the back cover
Screws for the Tech
Lock cover
Step #3 Remove the tech key cover
• Remove the 2 screws securing the tech lock cover to the
top of the back cover
Step #4 Unlock back cover
• Using the Tech Key, unlock and remove the Tech Lock
Step #5 Remove the back plate
• Use a #2 Phillips screwdriver to remove the 9 screws
from the back plate
IMPORTANT: Set aside all items
removed in Steps 1 through 5
for reinstallation later
To Next Page
Loading...
Need help?
General
