3.In the SIP config settings -> SIP 1 settings, add a call path, we assume that the
IP address of the other IP phone is 192.168.1.11, the phone number is 9265,
then we add a corresponding rule in the Dialing Rules so that the IP phone can
call the 9265 IP phone when dialing the 9265 number, just fill in the default port
5060 at the Server Port.
(Note: The configuration method of the IP phone of 9265 is the same from
setting up the network, adding the phone number, and doing the call routing
method. The only difference is that the content of 9265 Dialing Rules is the
phone number of 9264 and the 9264 IP phone’s IP address)
To Next Page
Loading...
