Presence detector Mini
– Switch on: Motion detection and brightness threshold not reached
– Switch off: No motion in the detection field and run-on-time elapsed or brightness
threshold exceeded
Motion detector function:
– Detection of motions for passageway security in buildings
– Switch on: Motion detection and brightness threshold not reached
– Switch off: No motion in the detection field and run-on-time elapsed
After reacting and switching on, the motion detection works independently of the bright-
ness.
Alert operation:
– Brightness-independent detection of motions in the detection field
– Switch on: After detection of an adjustable number of motions within the set monitoring
period
– Switch off: No persons in the detection field and run-on-time elapsed
5 Operation
Only for "Comfort" version:
Obey the battery safety instructions.
￭ Keep contacts of batteries and device free of grease.
￭ Insert the supplied battery with correct polarity (see IR remote control imprint)
Function buttons IR remote control
Button Function
¿ Detection of a motion is sent for function block
1. The automatic mode is exited.
Á End of a motion is sent for function block 1.
The automatic mode is exited.
À The automatic mode is activated again for
function block 1.
The ON state is first exited after a new motion
detection.
Adjustable buttons IR remote control
Button Function
´ Increasing sensitivity
² Reducing sensitivity
³ Resetting sensitivity to presetting
Ê Function block 1: Brightness threshold 10 lx
Ë Function block 1: Brightness threshold 50 lx
Ì Function block 1: Brightness threshold 150 lx
Í Function block 1: Brightness independent op-
eration
É Function block 1: Set current brightness as
brightness threshold
¼, Ï, Ð, Ñ,
Ò
Function block 1: Extend minimum run-on-time
(10 seconds) by the selected value
3 / 13
32589822 10867613 25.02.2020
To Next Page
Loading...
Need help?
General
