KNX GIRA - Page 11

Dimming actuator
Electronic transformers with LV-LED 20 ... 100 W
Inductive capacitive mixed load is not permitted.
With setting "LED trailing edge phase control" the connection power for HV-LED lamps
and electronic transformers with LV-LED doubles.
Power consumption 110 V per output
Incandescent lamps 20 ... 250 W
HV halogen lamps 20 ... 250 W
HV-LED lamps typ. 3 ... 50 W
Compact fl lamp. typ. 3 ... 50 W
Inductive transformers 20 ... 250 VA
Inductive transformers with LV-LED 20 ... 50 VA
Electronic transformers 20 ... 250 W
Electronic transformers with LV-LED 20 ... 50 W
Inductive capacitive mixed load is not permitted.
With setting "LED trailing edge phase control" the connection power for HV-LED lamps
and electronic transformers with LV-LED doubles.
Power boosters See power booster instructions
Connection
single stranded 0.5 ... 4 mm²
Finely stranded without conductor sleeve 0.5 ... 4 mm²
Finely stranded with conductor sleeve 0.5 ... 2.5 mm²
Fitting width 72 mm / 4 module
KNX
KNX medium TP256
Commissioning mode S-mode
Rated voltage KNX DC 21 ... 32 V SELV
Current consumption KNX 15 mA
Connection mode KNX device connection terminal
Dimming actuator, 2-gang, order no. 2172 00
Rated voltage AC 110 ... 230 V ~
Mains frequency 50 / 60 Hz
Power loss max. 4 W
Standby power max. 0.8 W
Ambient temperature -5 ... +45 °C
Storage/transport temperature -25 ... +70 °C
Power consumption 230 V per output
Incandescent lamps 20 ... 300 W
HV halogen lamps 20 ... 300 W
HV-LED lamps typ. 3 ... 60 W
Compact fl lamp. typ. 3 ... 60 W
Inductive transformers 20 ... 300 VA
Inductive transformers with LV-LED 20 ... 100 VA
Electronic transformers 20 ... 300 W
11 / 16
32575362 10867485 04.12.2019