KNX GIRA - Operation Details; Status Indication and Operating Modes; Manual Control Procedures: Temporary and Permanent

Dimming actuator
Status indication
The status LED
A1
… (5) indicate the states of the outputs.
– Off: Output switched off
– On: Output switched on
– Flashes slowly: Output in manual mode
– Flashes quickly: Output disabled via continuous manual mode
Operating modes
– Bus operation: Operation via push-button sensors or other bus devices
– Short-term manual operation: Manual operation locally with button field, automatic return
to bus operation.
– Continuous manual mode: Exclusively manual operation on the device
No bus operation is possible in manual mode.
No manual mode is possible in case of bus failure.
After a bus failure and restoration the device switches to bus operation.
After a power failure and restoration the device switches to bus operation.
The manual mode can be disabled in ongoing operation via a bus telegram.
Switching on the temporary manual control
Operation using the button field is programmed and not disabled.
￭ Press the c button briefly.
LED
A1
flashes, LED c remains off.
After 5 seconds without a button actuation, the actuator returns automatically to bus oper-
ation.
Switching off temporary manual operation
The device is in short-term manual mode.
￭ No button-press for 5 seconds.
- or -
￭ Press c button briefly as many time as necessary until the actuator leaves the short-time
manual mode.
LEDs
A1...
no longer flash, but rather indicate the output status.
Switching on permanent manual control
Operation using the button field is programmed and not disabled.
￭ Press the c button for at least 5 seconds.
LED c is illuminated, status LED
A1
flashes, continuous manual mode is switched on.
Switching off permanent manual control
The device is in continuous manual mode.
￭ Press the c button for at least 5 seconds.
LED c is off, bus operation is switched on.
Operating the outputs
The device is in continuous or short-term manual mode.
￭ Press the c button briefly as many times as necessary until the desired output is selec-
ted.
The LED of the selected output
A1...
flashes.
The LEDs
ON
/n and
OFF
/o indicate the status.
4 / 16
32575362 10867485 04.12.2019