14
1 - Power cord
2 - Drip loop
WARNING
To reduce the risk of electrocution,
keep all connections dry and off the ground.
Do not touch the plug with wet hands.
Position Of The Tile Saw (FIG 2 + FIG 3)
To avoid the possibility of the tool plug or outlet
getting wet, position tile saw to one side of a
wall-mounted outlet to prevent water from
dripping onto the outlet or plug.
The operator should arrange a “drip loop” in
the cord connecting the saw to the outlet.
The “drip loop” is that part of the cord below
the level of the outlet, or the connector if an
extension cord is used, to prevent water
traveling along the cord and coming in
contact with the outlet.
If the plug or outlet does get wet, DO NOT
unplug the cord. Disconnect the fuse or
circuit breaker that supplies power to the
tool then unplug and examine for the
presence of water in the outlet.
2 - Drip loop
Proper Position When
Using Extension Cords
2
3
• Do not allow familiarity with the Hand Held Tile Saw to cause carelessness. Remember that
one careless moment is enough to cause severe injury. Before attempting to use any tool, be
sure to become familiar with all of the operating features and safety instructions.
• Do not attempt to modify this tool or create accessories not recommended for use with this
tool. Any such atteration or modification is misuse and could result in a hazardous condition
leading to possible serious personal injury.
Know Your Hand Held Tile Saw
This Hand Held Tile Saw can be used for the purpose listed: cutting all types of tiling materials.
Before attempting to use the Hand Held Tile Saw, familiarize yourself with all of its operating
features and safety requirements.
WARNING
PREPARATION
SAFETY INFORMATION
1
2
2
To Next Page
Loading...
