9
OPERATING INSTRUCTIONS
3. Variable-speed Dial
Adjust the oscillating speed with the variable-speed
dial (F).
Turn the dial between “1” for the lowest speed and “6”
for the highest speed.
WARNING
• Never change the speed while the tool is running.
Failure to obey this caution could make you lose
control of the tool and result in serious personal
damage.
4. LED Work Light
The LED work light (C), located on the head of the multi-
tool, will illuminate when the On/Off switch (E) is moved
to the ON position. This provides additional light on the
surface of the workpiece for operation in lower-light
areas. The LED work light will turn off after the multi-tool
has been turned OFF.
a. The LED work light will blink rapidly if the tool has
stopped working in order to protect its internal
circuits; wait for the tool to cool down, at which point
in can be started again.
b. The LED work light will blink slowly to indicate that
the battery charge is very low.
4
C
3
F
To Next Page
Loading...
Need help?
General
