You can set the temperature on the heater
anywhere between “ ”and “ ” of the thermostat.
Turn the THERMOSTAT dial towards “ ” or “ ”
to get a lower or higher desired temperature. Once
you have chosen the desired temperature, the
heater will cycle on and off to maintain the desired
room temperature. For continuous heating, set the
thermostat towards “ ”.
C
ARE AND MAINTENANCE
1
.
C
AUTION: DO NOT let liquid enter the heater.
2
.
3
.
DO N
OT immerse the heater in water.
4
.
W
ait until the unit is completely dry before use.
5
.
6
.
7
. Clean the air intake or inside the unit after three months or if it appears to be blocking airflow. With
the heater unplugged, use a vacuum hose attachment or compressed air to blow out or clean
out any dirt, hair, or debris that may have built up around and inside the unit as this will obstruct
airflow.
To keep the heater clean, clean the outer shell with a soft, damp cloth. Use a mild detergent if
necessary. After cleaning, dry the unit with a soft cloth.
DO NOT use alcohol, gasoline, abrasive powders, furniture polish, or rough brushes to clean the
heater. This may cause damage or deterioration to the surface of the heater.
If you will not be using the heater for a while, take the batteries out of the remote control and store
for future use.
Store the heater in a cool, dry location when not in use. To prevent dust and dirt build-up, use the
original packaging to repack the unit.
WARNING: Before performing any maintenance task, turn off the unit, unplug the unit, and allow it to cool
completely.
OPERATING INSTRUCTIONS
C
3
3. Set the thermostat by turning the THERMOSTAT
dial clockwise or counter clockwise on the control
panel (C).
7
To Next Page
Loading...