Kobalt KBT2000 User Manual

5
NOTE:
Set-up
Connect garden hose to pressure
washer water intake.
Assemb le pressure washer gun to spray wand.
Connect desired pressure tip .
• Take one end of the hose off the holder.
• Remove the high pressure hose
completely from hose reel, then take the
other hose end off the holder.
(REFER TO MANUAL PAGE 14)
Insert high pressure hose into trigger
handle .
onnectih - eiTigh pressure hose to th
water outlet connector.
Turn on water at outlet.
Run water hose for 120 seconds with the
motor in OFF position. This helps drain air
from the tank and lines.
Connect power cord to wall outlet
Extension cord not recommended.
Turn on Pressure Washer
IMPORTANT: Ensure wateJ outlet is On
before turning power On to avoid damage
to the pump .
AUTO ON/OFF SWITCH: This Pressure washer is equipped
with an Auto Start/Stop feature.
To operate: Turn the power switch to the On (I) position. Pump will
pressurize and shut down immediately .
Once the trigger of the gun is depressed the unit will turn on.
(J) , the frame of the
axle to secure.
1 =-
(F) with upper
'hillips screwdriver
\
- Screws
le of the upper
onto the frame (2}.
1)
\
ories or need a service center?
!turn to Store
·6-456-8934

Kobalt KBT2000 Specifications

General

Brand	Kobalt
Model	KBT2000
Category	Pressure Washer
Language	English