OPERATING INSTRUCTIONS
14. OPERATING THE PRESSURE WASHER
Use
only
detergents designed
for
pressure washers.
Many
detergents may require mixing prior to
use. Prepare cleaning solution as instructed
on
the solution bottle.
a.
To
clean:
Pour detergent
in
the
detergent tank.
Install the black soap tip on the spray wand.
Start the pressure washer and spray the detergent on a dry surface using long, even, overlapping
strokes.
To
prevent streaking, do not allow detergent to dry
on
the
surface.
b.
To
rinse:
Using the 25• spray tip, spray away from the rinsing surface for approximate 10 seconds
to
allow
any remaining detergent to be flushed from the line.
Start at the top of the area to be rinsed
and
work down, overlapping the strokes.
For the most effective cleaning, the spray tip should be between 8
in
. and 24
in
. from the surface to
be
cleaned. If the spray is too close it can damage the surface.
15.
MOVING
THE PRESSURE WASHER
To
move the pressure washer:
Turn the pressure washer off. Point the spray wand in a safe direction and pull trigger to release
water
pressure.
Tilt the machine toward you until it balances
on
the wheels, then
roll
the machine to the desired
position.
20
CARE AND MAINTENANCE
A
wARNING
When servicing, use only identical replacement parts. Use
of
any
other parts may create a hazard or
cause product damage.
A
wARNING
Before inspecting, cleaning or servicing the machine, turn off the unit, unplug from the outlet, pull trig-
ger
to
release water pressure and disconnect the high pressure hose. Failure
to
follow these instruc-
tions
can
result in serious personal injury
or
property damage.
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most plastics are susceptible
to
damage from vari-
ous types
of
commercial solvents and
may
be
damaged by their use. Use clean cloths to remove dirt,
dust,
oil
, grease, etc.
A
wARNING
Do
not at any time let brake fluids, gasoline, petroleum-based products, penetrating oils, etc., come
in
contact with plastic parts. Chemicals can damage, weaken
or
destroy plastic which
may
result
in
serious personal injury.
Only the parts shown
on
the
parts list are intended
to
be
repaired
or
replaced
by
the customer.
All
other parts should
be
replaced at an authorized service center.
21
To Next Page
Loading...
Need help?
General
