A SYMBOLS
Some
of
the following symbols may
be
used on this product. Plea
so
study them and
lun111
tltutr mean-
ing. Proper interpretation
of
these symbols will allow you to opera
I<'
tho product bettor
.tnt!
ca
lm
SYMBOLS
DESIGNATION
EXPLANATION
-
v Volts Voltage
--
-
~
A
Amperes Current
Hz
Hertz Frequency (cycles per second)
w Watts
Power
no
No
Load Speed Rational speed, at
no
load
'V
Alternating Current Type
of
current
/min Per Minute
Revolutions, strokes, surface speed, orbits, etc., per
minute
A
Safety Alert Indicates a potential personal injury hazard.
~
Read The Operator's Manual
To
reduce the risk of injury, user must read
and
understand operator's manual before using this product.
e
Eye
Protection
Always
wear
eye protection with side shields marked to
comply with ANSI Z87.1.
~
Wet Conditions Alert
Do not expose to rain or use
in
damp
locations.
To
reduce the risk of injection
or
injury, never direct a
~
water system toward people
or
pets
or
place any body
~
Risk
of
Injection
part
in
the stream. Leaking hoses and fittings are also
capable
of
causing injection injury. Do not hold hoses
or
i
fittings.
[SJ
Kickback
To
reduce the risk of injury from kickback, hold the spray '
wand securely with both hands when the machine is on.
~
Failure to use
in
dry conditions and to observe safe
Electric Shock
practices can result
in
electric shock.
~
To
reduce the risk of injury or damage, DO NOT
~
Chemical Burns
USE
ACIDS
, ALKALINES, BLEACHES, SOLVENTS,
FLAMMABLE MATERIAL, OR INDUSTRIAL GRADE
SOLUTIONS
in
lhi~oduct.
4
A
SYMBOLS
The following signal words and meanings are intended to explain the levels of risk associated
with this product.
SYMBOL
SIGNAL
MEANING
DANGER
Indicates
an
imminently hazardous situation, which, if not
avoided, will result
in
death or serious iniurv.
WARNING
Indicates a potentially hazardous situation, which, if not
A
avoided, could result in death or serious injury.
Indicates a potentially hazardous situation, which, if not
CAUTION
avoided, mav result in minor or moderate iniurv.
CAUTION
(Without Safety Alert Symbol) Indicates a situation that may
result
in
property damage.
SERVICE
Servicing requires extreme care and knowledge and should be performed only by a qualified service
technician.
For
service, return the product to your nearest
AUTHORIZED
SERVICE
CENTER
for
repair. When servicing, use only identical replacement parts.
A
wARNING
•
To
avoid serious personal injury,
do
not attempt
to
use this product until
you
have read this Owner's
Manual thoroughly
and
understand it completely. If you
do
not
understand the warnings and
instructions
in
this Owner's Manual,
do
not
use
this product. Call1-866-456-8934 for assistance.
• e The operation of any power tool can result
in
foreign objects being thrown into your eyes, which
can result
in
severe eye damage. Before operating a power tool, always wear safety goggles,
safety glasses with side shields, or a full face shield when needed.
We
recommend a Wide
Vision Safety Mask for use
over
eyeglasses or standard safety glasses with side shields. Always
use eye protection that is marked to comply with ANSI Z87
.1.
SAVE THESE
INSTRUCTIONS
5
To Next Page
Loading...
Need help?
General
