10
OPERATING INSTRUCTIONS
kobalttools.com
• Turn on water supply at the faucet.
• Make sure the “ON/OFF” switch is in the “OFF” position.
The power switch has international symbols for ‘on’ and ‘off’: On (|) Off (O).
• Unwind the power cord completely and plug into a
grounded 120 volt outlet.
• Release the safety lock button on the spray gun by
pressing the safety lock button from right to left. While
pointing the spray gun in a safe direction, squeeze the
trigger on the spray gun until there is a steady stream of
water, letting the water and air out of the hose.
• Turn the power switch to the ‘ON’ (|) position. The unit
will turn on for 1 - 2 seconds and shut off. This is a
normal function of the auto start feature. Squeeze the
spray gun trigger to begin pressure washing.
• Squeezing rapidly will cause the auto start feature to
miss an on/off cycle that may prevent it from turning on
while squeezing trigger after rapid squeezing. Use slow
deliberate trigger pulls to avoid such symptoms.
OFF/0
ON/I
OFF/0
ON/I
Unlock
K
L
To Next Page
Loading...
