Kobalt SC1802LW User Manual

31
FILLING/CHANGING THE WATER RESERVIOR
(FIG. 27)
WARNING: When lling/draining water tray,
make sure wet tile saw is unplugged from
wall outlet.
To ll the reservoir with water
● Make sure the drain plug (X) on the water
tray is tight.
● Fill the water tray (K) with clean water.
Ensure the water level is between "MAX" (1)
and "MIN" (2) ll lines. Do not overll.
To change the reservior water:
●
Place a bucket under the drain plug (X).
Remove
the drain plug and allow the water
to empty into the bucket .
● Rinse the water reservoir thoroughly.
● Discard the waste water in accordance with
local regulations.
● Replace the drain plug (X) and rell water
tray with clean water.
EXTERNAL WATER CONTROLS (FIG. 28)
Water nozzles are adjustable to provide
maximum water for cutting and change water
spray direction.
● The water volume control (S) allows easy
adjustment of nozzles (OO) to provide water
volume. To provide maximum water volume,
turn the water volume control (S) clockwise.
To provide minimum water volume, turn the
water volume control (S) counterclockwise.
● The water angle control (T) allows easy
adjustment of nozzles (OO) to desired angle.
!
28
S
T
OO
1
K
X
FRONT OF SAW
2
27

Kobalt SC1802LW Specifications

General

Brand	Kobalt
Model	SC1802LW
Category	Saw
Language	English