What to do if there is no air pressure at my Kobalt SGY-AIR87TZ gun?
If you are experiencing no air pressure at the gun of your Kobalt Paint Sprayer, you should first check the air supply and air lines. Additionally, you can try increasing the fluid pressure at the tank, opening the fluid control screw, or thinning the material. Alternatively, consider changing to a pressure feed system.
How to unclog a Kobalt SGY-AIR87TZ nozzle?
To unclog a nozzle on your Kobalt Paint Sprayer, soak it in solvent to loosen the clog. Then, blow air through it until it is clean. For the orifices, use a broom straw or toothpick to clean them. Never use sharp tools to detach dried material.
What to do with dry packing on my Kobalt SGY-AIR87TZ Paint Sprayer?
If you have dry packing on your Kobalt Paint Sprayer, you should lubricate it. For pressure feed systems, consider replacing the fluid nozzle and needle with new ones and adjust them.
What to do if the packing nut is loose on my Kobalt SGY-AIR87TZ?
If the packing nut is loose on your Kobalt Paint Sprayer, tighten it, but not so tight as to grip the needle. If that doesn't resolve the issue, consider replacing the packing or lubricating it.
What to do if the packing around the needle valve is dried out on my Kobalt Paint Sprayer?
If the packing around the needle valve of your Kobalt Paint Sprayer is dried out: a) Back up the knurled nut, put a few drops of machine oil on the packing, and retighten the nut. b) Take off the fluid nozzle, clean the rear of the nozzle and the seat in the gun body. Replace the nozzle and tighten it to the body. c) Replace the seal.
What happens if the Kobalt Paint Sprayer gun held too far from surface?
If the Kobalt Paint Sprayer gun is held too far from the surface: a) Move the gun closer to the surface. b) Adjust the atomization pressure.
What happens if the Kobalt SGY-AIR87TZ Paint Sprayer gun held too close to surface?
If your Kobalt Paint Sprayer gun is held too close to the surface, move the gun further away from the surface.
What to do if the fan adjustment screw is not seating properly on my Kobalt Paint Sprayer?
If the fan adjustment screw on your Kobalt Paint Sprayer is not seating properly, clean or replace it.
General| Hose Length | 25 ft |
|---|---|
| Spray Pattern | Adjustable |
| Voltage | 120 V |
| Nozzle Size | 0.015 in |
| Tip Size | 0.015 in |
| Power Source | Corded Electric |
To Next Page