How to clean clogged nozzle on Kobalt SGY-AIR86TZ?
To clean a clogged nozzle on your Kobalt Paint Sprayer, soak the nozzle in solvent to loosen the clog, then blow air through until clean. To clean orifices, use a broom straw or toothpick. Never try to detach dried material with a sharp tool.
What to do if my Kobalt SGY-AIR86TZ will not spray?
If your Kobalt Paint Sprayer won't spray, check the following: * Ensure there is air pressure at the gun by checking the air supply and air lines. * If using an internal mix cap and pressure tank, increase the fluid pressure at the tank. * Open the fluid control screw. * If the fluid is too heavy for suction feed, thin the material or change to pressure feed.
Why does my Kobalt SGY-AIR86TZ have an improper spray pattern?
An improper spray pattern from your Kobalt Paint Sprayer can be due to several reasons: * The gun may be improperly adjusted. Re-adjust the gun carefully, following the instructions. * The air cap may be dirty. Clean the air cap. * The fluid tip may be obstructed. Clean it. * The needle may be sluggish. Lubricate it.
What to do if my Kobalt SGY-AIR86TZ Paint Sprayer has intermittent spray?
If your Kobalt Paint Sprayer has an intermittent spray, consider the following: * The packing around the needle valve may be dried out. Back up the knurled nut, put a few drops of machine oil on the packing, and retighten the nut. * The fluid nozzle may be loosely installed, or there may be dirt between the nozzle and body. Remove the fluid nozzle, clean the rear of the nozzle and its seat in the gun body, then replace the nozzle tightly to the body. * The needle sealing may be damaged. Replace the seal.
Why is my Kobalt SGY-AIR86TZ Paint Sprayer dripping from the fluid tip?
Dripping from the fluid tip of your Kobalt Paint Sprayer can occur due to: * Dry packing. Lubricate it. * A sluggish needle. Lubricate it. * A tight packing nut. Adjust it. * Worn fluid nozzle or needle. For pressure feed, replace with a new fluid nozzle and needle.
Why does my Kobalt SGY-AIR86TZ have a thin, sandy coarse finish?
A thin, sandy coarse finish with your Kobalt Paint Sprayer can be caused by: * Holding the gun too far from the surface. Move the gun closer to the surface. * The atomization pressure being set too high. Adjust the atomization pressure.
What to do if my Kobalt Paint Sprayer has fluid leakage from packing nut?
If there's fluid leakage from the packing nut of your Kobalt Paint Sprayer: * Tighten the packing nut, but not so tight as to grip the needle. * The packing might be worn or dry. Replace the packing or lubricate it.
Why does my Kobalt SGY-AIR86TZ produce a thick, dimpled finish resembling orange peel?
If your Kobalt Paint Sprayer produces a thick, dimpled finish resembling orange peel, move the gun further from the surface.
Protect eyes from expelled solvents during cleaning and flushing.
Covers air supply, hose control, distance, and child operation rules.
Includes tool maintenance, clothing, footing, hearing protection, and ventilation.
General| Brand | Kobalt |
|---|---|
| Model | SGY-AIR86TZ |
| Category | Paint Sprayer |
| Language | English |
To Next Page