What to do if my Kobalt Paint Sprayer has low or no pressure?
If your Kobalt Paint Sprayer has low or no pressure, it could be due to several reasons: the battery may be out of charge, the switch might be in the "off" position, or the tip nozzle could be stuck. To resolve this, fully charge the battery, turn the switch to the ON position, and unscrew the nozzle to remove any debris.
Why is my Kobalt 2644068 Paint Sprayer tank leaking at the pump?
If your Kobalt Paint Sprayer tank is leaking at the pump, the hose clamp may be loose. To fix this, simply tighten the hose clamp.
What to do if my Kobalt 2644068 machine does not start?
If your Kobalt Paint Sprayer doesn't start, it could be because the battery isn't charged or the battery is too cold. Charge the battery by following the procedures in the battery and charger manual. If the battery is too cold, remove it from the backpack sprayer, place it on the charger, and allow it to charge for 10 minutes or until the charging light turns green. Then, remove it from the charger and install it in the backpack sprayer for use.
Why is liquid leaking from the lid of my Kobalt 2644068 Paint Sprayer?
If liquid is leaking from the lid of your Kobalt Paint Sprayer, it could be that the lid isn't screwed on tightly enough, or the seal is cracked or damaged. Try tightening the lid. Also, lubricate the seal, and replace it if necessary.
How to fix a Kobalt Paint Sprayer tank that starts to collapse?
If the tank of your Kobalt Paint Sprayer starts to collapse and the lid cannot be unscrewed due to a vacuum, the vent holes in the tank lid may be clogged. Remove the cap and use a small wire to unclog the holes. Clean the cap, check the valve, lubricate the check valve, and then reinstall.
What causes liquid leaks in a Kobalt 2644068 Paint Sprayer?
Liquid leaks in your Kobalt Paint Sprayer may be due to a loose nut or a cracked or damaged rubber seal. To resolve this, tighten the nut and/or replace the seal and lubricate it.
What to do if my Kobalt 2644068 Paint Sprayer tank leaks at the hose connection?
If your Kobalt Paint Sprayer tank leaks at the hose connection, the clamp may be loose or damaged. Try tightening the clamp, and if it's damaged, replace it.
What should I do if the diaphragm is leaking in my Kobalt 2644068?
If the diaphragm in your Kobalt Paint Sprayer is leaking, it's likely damaged and needs to be replaced.
What to do if my Kobalt Paint Sprayer tank leaks at the pump connection?
If your Kobalt Paint Sprayer tank leaks at the pump connection, the seals are likely damaged. You should replace the damaged seals.
General safety precautions for using the Kobalt 40-volt backpack sprayer.
Steps to connect the nozzle and wand to the gun handle.
Steps to connect the tank lid to the main tank.
Instructions for inserting and securing the battery pack into the sprayer.
Steps to safely detach the battery pack from the sprayer.
General| Maximum Working Pressure (PSI) | 3000 |
|---|---|
| Hose Length (ft) | 25 |
| Orifice Size (in) | 0.015 |
| Spray Tip Included | Yes |
| Power Source | Electric |
To Next Page