To Next PageTo Next Page
Need help?Do you have a question about the Koch TWINTONE and is the answer not in the manual?
Selector for low and high impedance audio inputs.
Primary control for overall signal amplification level.
Adjusts the gain stage for overdrive and distortion characteristics.
Affects the high-frequency response and tonal character.
Interface for connecting external effects processors.
Adjusts the intensity of the reverberation effect.
Terminals for connecting external loudspeaker cabinets.
Line-level output for connecting to recording equipment.
Jack for connecting headphones for private listening.
Connection point for the main AC power supply.
Activates or deactivates the amplifier's main power.
Puts the amplifier into a low-power standby state.
Potentiometer to minimize hum noise from the power supply.
Selector for low and high impedance audio inputs.
Primary control for overall signal amplification level.
Adjusts the gain stage for overdrive and distortion characteristics.
Affects the high-frequency response and tonal character.
Interface for connecting external effects processors.
Adjusts the intensity of the reverberation effect.
Terminals for connecting external loudspeaker cabinets.
Line-level output for connecting to recording equipment.
Jack for connecting headphones for private listening.
Connection point for the main AC power supply.
Activates or deactivates the amplifier's main power.
Puts the amplifier into a low-power standby state.
Potentiometer to minimize hum noise from the power supply.
General| Power Output | 50 Watts |
|---|---|
| Channels | 2 |
| Frequency Response | 20 Hz - 20 kHz |
| EQ | 3-band (Bass, Middle, Treble) |
| Reverb | Spring Reverb |
| Tubes | 4x 12AX7, 2x EL34 |
