Need help?Do you have a question about the Kodak 600 and is the answer not in the manual?
General| Type | Slide Projector |
|---|---|
| Projection Technology | Optical Projection |
| Speaker | No |
| Film Format | 35mm |
| Lamp | 300W |
| Carousel Capacity | 80 slides |
| Resolution | N/A (Analog Projector) |
| Contrast Ratio | N/A (Analog Projector) |
| Aspect Ratio | 3:2 |
| Input Ports | None (Analog Projector) |
| Throw Distance | Variable, depends on lens |
Specifies the operating voltage and frequency for the projector.
Details the types of projection lamps used for different models.
Outlines the dielectric strength test procedure and requirements.
Explains the function of the dropping resistor and its resistance values.
Describes the projector's optical system, including lenses and condensers.
Details the types of slide trays and emergency release mechanism.
Explains the function of the select button for different models.
Describes the automatic timer function for specific models.
Details the remote control unit and its operation.
Explains the thermal fuse as a safety device and its symptoms when failed.
Describes the capacitor's role in suppressing electrical noise.
Details the step-by-step process of a forward projector cycle.
Explains the purpose and operation of the half-cycle function.
Describes the forward and reverse operation based on the direction lever.
Provides instructions for removing the projector's base cover.
Details the procedure for replacing the thermal fuse assembly.
Instructions for removing the lamp and mirror mount bracket.
Step-by-step guide to remove the lamphouse door assembly.
Instructions for removing the main drive motor.
Details the process for replacing the fan or fan belt.
Procedure for removing the front grille assembly.
Guide to removing the mechanism and lens mount assemblies.
Instructions for disassembling the lens mount assembly.
Steps for disassembling the mechanism assembly.
Procedure for disassembling the cam shaft.
Details on the automatic timer components.
Instructions for replacing the worm-pulley or mechanism belt.
Procedure for removing and replacing the slide lever ramp.
Steps to disassemble the remote control unit.
Instructions for removing the carrying handle or front nameplate.
Procedure for removing the rear leveling foot assembly.
How to adjust the cycle solenoid for minimum noise.
Details on adjusting the locator lever for proper slide tray engagement.
Instructions for adjusting the slide lever for correct slide height.
Steps to check and adjust the gate alignment using a specific gauge.
Procedure for aligning the projector mirror using a special tool.
Lists possible causes and remedies for projector not cycling.
Troubleshooting steps for continuous cycling issues.
Diagnosing issues with the projector indexing.
Troubleshooting projector reverse operation failures.
Causes and remedies for projectors that always reverse.
Diagnosing and fixing noisy projector operation.
Troubleshooting issues with tray rotation.
Remedies for shutter hang-up issues.
Troubleshooting a dead focus motor.
Diagnosing remote focus failure.
Steps to resolve slides jamming in the projector.
Troubleshooting reasons for projector not starting.
Addressing issues with uneven projector illumination.
Lists special tools required for servicing the projector.
Details lubricants and their application points for projector maintenance.
Electrical diagram for Kodak Carousel Models 600 and 600H.
Electrical diagram for Kodak Carousel Models 650 and 650H.
Electrical diagram for Kodak Carousel Model 700.
Electrical diagram for Kodak Carousel Models 750 and 750H.
Electrical diagram for Kodak Carousel Models 800 and 800H.
To Next Page
