Getting help
www.kodak.com/go/support
39
Troubleshooting
Camera problems
Status Solution
Camera does not
turn on/off, buttons
and controls do not
function
■ Make sure the batteries have a charge and are installed correctly
(see page 2).
■ Turn the camera off, then on again.
In Review, a blue or
black screen is
displayed instead of
a picture
■ Transfer
all
pictures to the computer (see page 31).
■ Take another picture.
Pictures remaining
number does not
decrease after taking a
picture
■ Continue taking pictures. The camera is operating normally.
(The camera estimates the number of pictures remaining after each
picture is taken, based on picture size and content.)
Flash does not fire ■ Check the flash setting, and change as needed (see page 7).
NOTE: The flash does not fire in all modes.
Memory card is almost
or entirely full
■ Transfer the pictures to the computer (see page 31).
■ Delete pictures from the card (see page 15) or insert a new card.
Battery life is short ■ Make sure the correct battery type is installed (see page 48).
■ Wipe the contacts with a clean, dry cloth before inserting a
battery in the camera.
■ Insert new or charged batteries (see page 2).
You cannot take a
picture
■ Turn the camera off, then on again.
■ Depress the Shutter button all the way (see page 5).
■ Insert new or charged batteries (see page 2).
■ Memory is full. Transfer pictures to the computer (see page 31),
delete pictures (see page 15), or insert another card.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
