Using Wi-Fi mode—EX models only
www.kodak.com/go/support
20
Perform the setup
1 Make sure your computer and router are on.
2 Remove all memory cards or other USB devices from your frame. Turn it on.
The first time you turn on your frame (after you select your language), the Network
connection screen appears.
3 When asked "Do you want to connect your frame to
a wireless network?", select Yes, then press OK to
begin scanning for available networks.
If you select No, you can set up the network later: See
Set up your network at a later time, page 21.
4 Select your network from the list of available
networks, then press OK.
The frame connects to your network and then scans
for available computers or other devices.
NOTE: If you have network security turned on, you are prompted to
enter your security information. If you are not sure of your
network information, contact your system administrator or
the person who set up your network.
5 Select your home computer from the list, then press
OK.
6 When the Setup complete message is displayed,
press OK.
If you are unable to connect to your network or see
your home computer, go to the troubleshooting help
on page 29 of this guide or visit
www.kodak.com/go/digitalframesupport
.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
