46 www.kodak.com/go/support
Troubleshooting
Stored pictures are
corrupted.
■ Retake pictures. Do not remove card while the camera is accessing it.
Keep rechargeable batteries charged.
■ Transfer pictures to the computer (see page 37), then format the card
in the camera (see page 34).
Caution: Formatting a card deletes all pictures and videos,
including protected files.
In Review mode,
you do not see a
picture (or the
expected picture)
on the LCD screen.
■ Check the image storage location setting (see page 32). If the problem
persists, visit www.kodak.com/go/m1063support, and select
Interactive Troubleshooting & Repairs.
In Review mode, a
blue or black
screen is displayed
instead of a
picture.
■ Take another picture.
■ Transfer the picture to the computer (see page 37), then format the
card in the camera (see page 34).
If the problem persists, visit www.kodak.com/go/m1063support, and
select Interactive Troubleshooting & Repairs.
Caution: Formatting a card deletes all pictures and videos,
including protected files.
Picture is too light.
■ Decrease Exposure Compensation (see page 35).
■ Turn off the flash, then move back from the subject.
Picture is not clear.
■ Clean the lens (see page 56).
■ Make sure your camera is not in Close-up mode.
■ Move so there is at least 23.6 in. (60 cm) between the camera and the
subject.
■ Place the camera on a flat, steady surface or use a tripod.
If... Try one or more of the following
To Next Page
Loading...
Need help?
General
Weight and Dimensions
