Kodak EasyShare S510 - Attaching the frame stand; Turning on the frame

Getting started
www.kodak.com/go/digitalframesupport 3
Attaching the frame stand
1 Place the square tab of the stand into the slot on the
back of the frame.
2 Slide the tab into the slot until it’s secure.
NOTE: To change the orientation from landscape to portrait ,
see page 13.
Turning on the frame
CAUTION:
Do not use this power cable with other devices, including digital
cameras; the higher voltage (12 V) required by the frame will cause
serious damage to other devices.
■ P
l
ug in t
h
e power ca
bl
e inc
l
u
d
e
d
wit
h
t
h
e
f
rame.
The frame turns on automatically. The language screen
appears the first time you power up your frame.
Your power cable may look different from the one pictured.
Use the plug that accommodates your type of power outlet.