Slide Show does not run on an
external video device
● Adjust the camera Video Out setting to NTSC or PAL
(
).
● Make sure the external device settings are correct.
(See the device's user's guide).
Computer does not communicate
with the camera
● Make sure the battery is charged and installed
correctly (see Loading the KLIC-7003 battery).
● Turn on the camera.
● Make sure the USB cable model U-8 is connected to
the camera and the computer (see Using the USB
cable). (If using an EasyShare dock, check all cable
connections. Make sure the camera is seated on the
dock.)
● Make sure EasyShare software is installed (see
Installing the software).
Picture quality problems
Status Solution
Picture is not
clear
● To automatically set exposure and focus, press the Shutter button
halfway. When the framing marks turn green, press the Shutter button
completely down to take the picture.
● Clean the lens (see Care and maintenance).
● Make sure the camera is not in Macro mode if you are more than 27.6 in.
(70 cm) from your subject.
● Place the camera on a flat, steady surface or use a tripod (especially in
high-zoom settings or in low light).
Picture is too dark
● Reposition the camera for more available light.
● Use Fill flash (see Using the flash) or change your position so light is not
behind the subject.
● Move so that the distance between you and the subject is within the
effective flash range. (See camera specifications starting on see Camera
specifications.)
● To automatically set exposure and focus, press the Shutter button
halfway. When the framing marks turn green, press the Shutter button
completely down to take the picture.
http://www.kodak.com/global/en/service/publications/urg0...ml?chapsec=urg00665c6s0&pq-path=10/3905/7168/10510/10540 (3 of 4)19/01/2007 16:36:56
To Next Page
Loading...
Need help?
General
