Kodak EasyShare Z1012 IS User Manual

Appendix
www.kodak.com/go/support
59
Your rights
Some states or jurisdictions do not allow exclusion or limitation of incidental or
consequential damages, so the above limitation or exclusion may not apply to you.
Some states or jurisdictions do not allow limitations on how long an implied warranty
lasts, so the above limitation may not apply to you. This warranty gives you specific
rights, and you may have other rights which vary from state to state or by jurisdiction.
Outside the United States and Canada
In countries other than the United States and Canada, the terms and conditions of
this warranty may be different. Unless a specific Kodak warranty is communicated to
the purchaser in writing by a Kodak company, no warranty or liability exists beyond
any minimum requirements imposed by law, even though defect, damage, or loss may
be by negligence or other act.
Regulatory compliance
FCC compliance and advisory
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate radio frequency energy
and, if not installed or used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures: 1) reorient or relocate the
receiving antenna; 2) increase the separation between the equipment and the
receiver; 3) connect the equipment to an outlet on a circuit different from that to
which the receiver is connected; 4) consult the dealer or an experienced radio/TV
Kodak EasyShare Z1012 IS digital camera

Kodak EasyShare Z1012 IS Specifications

General

Megapixel	10.1 MP
Sensor type	CCD
Image stabilizer	Yes
Image sensor size	1/2.33 \
Supported aspect ratios	4:3
Maximum image resolution	3648 x 2736 pixels
Still image resolution(s)	2048 x 1360, 2048 x 1536, 2592 x 1728, 2592 x 1944, 3648 x 2432, 3648 x 2736
Digital zoom	12 x
Optical zoom	5 x
Focal length range	2.8 - 4.8 mm
Interface	USB
Digital SLR	No
Power source	KLIC-8000
Camera shutter speed	1 - 1/3200 s
Focal length (35mm film equivalent)	33 - 396 mm
Auto focusing (AF) modes	Multi Point Auto Focus
Manual focusing range (tele)	0.6 - ∞ m
Manual focusing range (wide)	0.12 - ∞ m
Light metering	Centre-weighted, Spot
ISO sensitivity	64, 100, 200, 400, 800, 1600, 3200, 6400
Light exposure modes	Shutter priority AE
Flash modes	auto, fill-in, Flash off, Red-eye reduction
Flash range (tele)	0 - 6.2 m
Flash range (wide)	0.10 - ∞ m
Flash recharging time	1.3 s
Internal memory	32 MB
Compatible memory cards	sd
Motion JPEG frame rate	30 fps
Video formats supported	AVI
Maximum video resolution	640 x 480 pixels
Display diagonal	2.5 \
USB version	2.0
Scene modes	Backlight, beach, Candlelight, Children, Close-up (macro), Documents, dusk, Fireworks, Landscape (scenery), Museum, Night, Night landscape, Night portrait, Panorama, party (indoor), Portrait, self-portrait, Sports, Sunset
Photo effects	black&white, Neutral, Sepia, Vivid
White balance	auto, daylight, Fluorescent, Shade, Tungsten
Camera playback	single image, slide show
Self-timer delay	2 s
Product color	Black
Battery type	Rechargeable
Battery technology	Alkaline
Number of batteries supported	2
Viewfinder type	Electronic
Camera shutter type	Mechanical

Weight and Dimensions

Depth	76.6 mm
Width	108.5 mm
Height	74.2 mm
Weight	325 g