50 www.kodak.com/go/support
Troubleshooting
Picture quality problems
If... Try one or more of the following
Picture is too dark
or underexposed
■ Reposition camera for more available light.
■ Use Fill flash (page 26) or change your position so light is not behind
the subject.
■ Move so that the distance between you and the subject is within the
effective flash range (page 9).
■ To automatically set exposure and focus, press the Shutter button
halfway. When the Ready light glows green, press the Shutter
button completely down to take the picture.
■ Adjust the exposure compensation (page 32).
Picture is too light
■ Reposition camera to reduce the amount of available light.
■ Turn flash off (page 26).
■ Move so that the distance between you and the subject is within the
effective flash range (page 9).
■ To automatically set exposure and focus, press the Shutter button
halfway. When the Ready light glows green, press the Shutter
button completely down to take the picture.
■ Use P mode to adjust the exposure compensation.
Picture is not clear
■ To automatically set exposure and focus, press the Shutter button
halfway. When the Ready light glows green, press the Shutter
button completely down to take the picture.
■ Clean the lens (page 62).
■ Make sure camera is not in Close-up mode if you are more than
27.6 in. (70 cm) from your subject.
■ Place the camera on a flat, steady surface or use a tripod, especially
in high-zoom settings or in low light.
To Next Page
Loading...
