SERVICE MANUAL
6 30APR96 – SM4530-1
[11] Lift the BLOWER COVER ASSEMBLY up.
[12] Remove the 3
Hex
1/4 in. SCREWS from the MOTOR.
[13] Lift the MOTOR until you observe the FAN BELT and MECHANISM BELT.
[14] Remove the FAN BELT and MECHANISM BELT off the MOTOR PULLEY. Use SPRING HOOK TL-1165.
Caution
Move the MOTOR to allow access to the parts; wires are still connected to the MOTOR. Do not cause damage to
the MOTOR wires.
[15] N.P. only: Remove the RETAINER CLIP from the FAN SHAFT.
[16] Painted Models only: Remove the FAN CAP, E-RING, SPRING, and WASHER.
[17] Pull the FAN up and off the FAN SHAFT to allow access to the FAN BELT.
[18] Remove the FAN BELT.
[19] N.P. only: Remove the 3
Torx
SCREWS from the FAN SHAFT ASSEMBLY.
[20] Lift and remove the FAN SHAFT ASSEMBLY.
A008_0172HA
CORK
WASHER
MOTOR
SCREW
MECHANISM
BELT
RETAINER
CLIP
FAN
FAN PLATE
ASSEMBLY
FAN
BELT
SCREW (3)
BLOWER
ASSEMBLY
FAN CAP
E-RING
SPRING
WASHER
FAN
SCREW
WASHER
FAN PLATE
Painted PROJECTOR
A008_0172HCA
To Next Page
Loading...
