12 KODAK EKTAGRAPHIC III Slide Projector
Operation
Screen Image Use the elevating foot to horizontally center the projected image on the
screen. To release the foot, press the release button, while lifting the front of
the projector to the desired height. Use the elevating wheel to make fine
adjustments.
If the image is not level, make an adjustment by turning the leveling foot at
the rear of the projector.
Timer
(Models AMT & ATS
only)
To time your slides, use the timer switch for slide changes from 3 to
22 seconds.
To interrupt the timer, press either
the forward or reverse button. For
manual operation, slide the timer
switch to Off.
To Next Page
Loading...
