AUTO FILL
PM
Camera Identification LCD Panel
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause
undesired operation.
NOTE: Your model camera has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits provide rea-
sonable protection against interference in residential use. The camera generates, uses
and can radiate radio frequency energy and, if not used in accordance with the instruc-
tions, may cause interference to radio communications. There is no guarantee that inter-
ference will not occur. If this camera does cause interference to radio or television re-
ception, which can be determined by turning the camera off and on, you may reduce the
interference by the following:
— Reorient or relocate the receiving antenna.
— Increase the separation between the camera and the receiver.
— Consult the dealer or an experienced radio/television technician for help.
Changes or modifications not approved by the party responsible for compliance could
void the user’s authority to operate the equipment.
10 LCD panel
11 viewfinder eyepiece
12 flash/camera-ready-
lamp indicator
13
ON
/
OFF
switch
14 flash/option button
15 self-timer button
16 film-door latch
17 strap post
18 film chamber
19 film door
20
film-rewind button
21 ENTER
22 SELECT
23 tripod socket
24 auto-flash symbol
25 red-eye-reduction
symbol
26 fill-flash symbol
27 flash-off symbol
28 mode-selector
arrow
29 infinity-focus
symbol
30 battery symbol
31 self-timer symbol
32 picture counter
33 date and time
display
34 nightview symbol
This Class B digital apparatus meets all requirements of
the
Canadian Interference-Causing Equipment Regulations
10
14
13
11
12
16
17
22
21
23
15
1819
20
25
27
2624
29
30
31
3233
34
28
To Next Page
Loading...
Need help?
General
