4 A-61837 September 2016
.
10 Gap release toggle switch — push in to adjust the space between the
feed module and separation roller for documents that require special
handling.
11 Print location indicators — these detent positions (at the edge of the
input elevator) make is easier to see where the print positioning will be on
the paper.
12 Input elevator extender — pull this extender out to accommodate
documents longer than 27.9 cm (11 inches).
13 Input elevator — holds up to 500 documents (20 lb / 80g/m
2
). The input
elevator can be set to accommodate stacks of 25-, 100-, 250- or 500-
documents. The input elevator can be folded up when it is not in use.
14 Input elevator side guides — slide the guides in or out to accommodate
the document size you want to scan. Side guides can be left-, center- and
right-adjusted to accommodate documents of various widths. The side
guides can also be locked into position.
15 Feed module release lever — push this lever to the right to release the
feed module for cleaning or replacement. When using this release lever,
the scanner cover must be open.
To Next Page
Loading...
