59
SOLTARO
Step 1. Use a custom-made RJ45 cable to connect inverter and Lithium battery.
Please take notice for parallel system:
1. Only support common battery installation.
2. Use one custom-made RJ45 cable to connect any inverter (no need to connect to a specific inverter) and
Lithium battery. Simply set battery type of this inverter to “SOL” in LCD program 5. The remaining inverters
are set as “USE”.
Step 2. Open DC isolator and switch on Lithium battery.
Step 3. Turn on the inverter.
Step 4. Be sure to select battery type as “SOL” in LCD program 5.
If communication between the inverter and battery is successful, the battery icon on LCD display will
“flash”. Generally speaking, it will take longer than 1 minute to establish communication.
To Next Page
Loading...
