67
Connecting to your Printer
1. Make sure both the camera and printer are turned on.
2. Connect one end of the supplied USB cable to the USB port on your camera.
3. Connect the other end of the cable to the USB port on the printer.
If the camera is not connected to a PICTBRIDGE™ compatible printer, the following error message will appear
on the LCD.
The error message above will also appear if the USB Mode is set
incorrectly, in which case you should disconnect the USB cable,
check the USB Mode settings, ensure that the printer is turned on,
and then try connecting the USB cable again.
Connection Failed!
To Next Page
Loading...
