Kodak PIXPRO SP360 - Page 39

38
Flat Adhesive Mount: For tacking onto a skateboard or other at
objects
Installation method:
Therearetwotypesofadhesivemounts:atandcurved.Youmayselectbasedontheshapeoftheobjecttobe
used.
Bothtypescanbeassembledinthesameway,taketheadhesivemount(at)asanexample:
1. Assemble the adhesive mount or the waterproof housing ( 36 / 37).
2. Tie one end of the rope to the adhesive mount and the other end to the standard or waterproof housing.
3. Assemble the adapter, pre-tightening the nut and adhesive mount according to the direction illustrated in the
picture. First press the adapter into the adhesive mount and then rotate and tighten the pre-tightening nut.
4. Tack the double-sided adhesive at the bottom of the adhesive mount to the object to be used.
The double-sided adhesive is disposable. It should be replaced by a new one after being peeled off.
Curved Adhesive Mount: For tacking onto a helmet or other curved
objects
Pre-tightening nut
Adhesive Mount
Adapter
Double-sided adhesive