Kodak Portrait - Care and Maintenance; Firmware Updates; Printer Care - Hotends

!
!
21
Calibration: Calibration of nozzles and bed.
Cloud: To view the Cloud print queue.
Manual printer control!
!
In this screen (Setup » Extras » Controls) you can manually raise and lower
the print platform, extrude and retract filament from the left and right
extruders or change spools, or control the lights.
CARE AND MAINTENANCE
Updating
To make sure your KODAK Portrait 3D Printer is up-to-date with the latest
features we recommend that you periodically check for firmware updates by
connecting your printer to the Internet and selecting Setup » Extras »
Update. !
Printer care
• Whenever necessary to clean stray filament around the nozzles, set the
temp for both Hotends to 150º C (Setup » Extras » Controls). Wait for
the material on the outside of the nozzle to get soft and remove it using
the tweezers from your toolkit.
WARNING
:
Make sure the Hotends and the heatbed are cool before
touching them.!
!
!
!
!
!
!