26 A-61818 April 2014
• Based on Size: images will be considered blank based on the size of
the image that would be given to the scanning application (i.e. after
all other settings have been applied).
- Final image size: allows you to select the minimum image size that
the scanner will consider to be non-blank. Any image that is less
than this value will be considered blank and will not be given to the
scanning application. The values range from 1 to 1000 KB (1 KB
equals 1024 bytes).
Barcode — allows you to configure the scanner to search your images
for a barcode. The scanner will search each image and decode the first
barcode it finds and return the information to the scanning application.
The following barcodes can be detected:
Interleaved 2 of 5
Code 3 of 9
Code 128
Codabar
UPC-A
UPC-E
EAN-13
EAN-8
PDF417
• On: turns barcode detection on.
To Next Page
Loading...
