Shipment and Delivery 21
Shipment and Delivery
Responsibilities
The customer must provide Kodak with delivery instructions. and the customer
must transport all of the shipping crates to the installation location and unload the
shipping crates. However, the customer must not unpack the shipping crates. Kodak
recommends that the customer use professional riggers to unload the crates. Dock
level (a vertical distance from ground to dock of 1.2 m (4 ft.)), and the ability to
handle a 15.9 m (53 ft.) trailer are required.
Kodak representatives will unpack the shipping crates and install the device.
Forklift
The customer must provide a forklift or crane with a minimum 2300 kg (5000 lb.)
capacity for unloading of the equipment. The forks must be 1140 mm (45 in.) long
and a maximum of 152 mm (6 in.) wide. The span should be approximately 580 mm
(23 in.).
The forklift must be capable of safely lifting the device and crate with the center of
gravity as shown in Figure 7.
Figure 7: Center of gravity for lifting device
The forks must be inserted from the front and should be centered on the length of
the device. The output device is equipped with casters, so it may be rolled into
position once it is on the ground.
Ground crate with device: X=860 mm (34 in.)
Air crate with device: X=890 mm (35 in.)
Device only: X-710 mm (28 in.)
To Next Page
Loading...