ThermoFlex Wide II Site Preparation
Guide
Introduction
Please take a few moments to read through this document. It provides guidelines for
preparing your site for the Kodak® ThermoFlex® Wide II platesetter installation.
Your service representative will help you to ensure that your site meets all the
requirements. Proper preparation will help to prevent unnecessary problems and
delays when installing the device.
The following topics are discussed:
• Device configuration
• Floor space requirements
• Device dimensions
• Weight requirements
• Electrical requirements
• Debris removal system requirements
• Environmental conditions
• Ventilation requirements
• Network/modem requirements
• Processor specifications
With your service representative, complete the Site Inspection Checklist in
Appendix B.
Tools Needed
• Microscope (100X recommended)
• Dotmeter: Centurfax CCDot, BetaFlex 330 or equivalent
• Press sheet densitometer (recommended): GretagMacbeth® D19C or D196,
X-Rite® 400 series, Tobias IQ150. All with relative density and dot area
(Murray-Davies) functions.
To Next Page
Loading...