Koden MDC-2200 series User Manual (English)

Other manuals for Koden MDC-2200 series

Quick Start Guide2 pages

Specifications2 pages

Questions and Answers:

S
Sarah BrownSep 13, 2025
What to do if speed over ground input failed on Koden MDC-2200?
- R
  Robert WilliamsonSep 13, 2025
  If the speed over ground input failed under use of ground stabilization on your Koden Marine Radar, confirm sensor operation for speed over ground and GPS conditioning.
G
Garrett JoyceAug 25, 2025
What to do if there is no heading input on Koden MDC-2200 Marine Radar?
- S
  Sonya LewisAug 25, 2025
  If you are experiencing a lack of heading input on your Koden Marine Radar, and you've attempted to select a display mode other than H-UP, ensure that a heading input is available before changing the display mode.
J
john87Aug 25, 2025
What happens if there is no speed input on Koden Marine Radar?
- R
  rossdanielAug 26, 2025
  If you attempt to acquire ATA without speed input on your Koden Marine Radar, ensure you input speed to acquire ATA.
L
lritterAug 26, 2025
How to fix 'No signal on Heading' on Koden MDC-2200 Marine Radar?
- C
  curtiswilsonAug 26, 2025
  If you are getting a 'No signal on Heading' message on your Koden Marine Radar, confirm the reception of HDT, HDG, HDM, VTG, RMC, or RMA signals.
M
Molly SpenceSep 13, 2025
Why did my Koden Marine Radar change to head up mode?
- D
  diana86Sep 13, 2025
  Your Koden Marine Radar changed to head up mode because heading related signals cannot be input in display mode except H-UP. Ensure all heading related signals are functional for proper display mode.
K
Kim GarciaSep 14, 2025
Why did my Koden Marine Radar change to relative bearing?
- H
  Heather WigginsSep 14, 2025
  Your Koden Marine Radar changed to relative bearing because heading related signals cannot be input in EBL true bearing mode. Make sure all required heading signals are available.
T
Timothy CoxSep 6, 2025
What should I do if there is no trigger signal on Koden MDC-2200?
- M
  Michael ThomasSep 6, 2025
  If your Koden Marine Radar has no trigger signal, inspect and repair the transmitter PCB, as the cause is a transmitter PCB malfunction.
K
kenneth23Sep 7, 2025
What does a checksum error mean on Koden MDC-2200 Marine Radar?
- A
  Antonio LucasSep 7, 2025
  A checksum error on your Koden Marine Radar indicates there is a strong noise source near the operation table. Identify and eliminate the strong noise source near the operation table.
S
Stephanie ThomasSep 1, 2025
What to do if the operation panel is not connected on Koden MDC-2200 Marine Radar?
- T
  Terry GarciaSep 1, 2025
  If the operation panel is not connected on your Koden Marine Radar, reconnect the operation panel connector.
R
Robert BirdAug 31, 2025
What causes 'No video signal' on Koden MDC-2200?
- A
  Amy JonesAug 31, 2025
  A 'No video signal' error on your Koden Marine Radar may be caused by a front-end malfunction or IF Amp malfunction. Check and repair the front-end circuit and IF amplifier.