Koden MDC-7912 - 5.4 On-Board Repair

MDC-7000/7900 Series Chapter 4 Setup after installation
0092669002-07 4-11
4.1.13 MOUSE SPEED
This menu sets the operation speed of the USB Mouse/Trackball.
(1) Press MENU key to display “Menu”.
Select [MAINTENANCE] => [STARTUP] => [MOUSE SPEED] => select [FAST], [MEDIUM] or
[SLOW], and press ENT key.
Setting value: FAST, MEDIUM, SLOW
4.1.14 MONITOR SIZE
This MONITOR SIZE menu sets the size of the used monitor display.
(1) Press MENU key to display “Menu”.
Select [MAINTENANCE] => [STARTUP] => [MONITOR SIZE]
(2) Select used monitor display size [19INCH] or [23INCH].
(3) Press ENT key.
(4) Turn off the power, and then turn on. This setting is valid in the restart.
Setting value: 19 INCH, 23INCH
4.1.15 TX HOUR DISP
This radar can display the total transmitting time of the radar at wait or standby mode.
(1) Press MENU key to display “Menu”.
Select [MAINTENANCE] => [STARTUP] => [TX HOUR DISP] => select [WAIT] or [STANDBY],
and press ENT key.
WAIT: TX HOUR is displayed during countdown time.
STANDBY: TX HOUR is displayed during standby mode.