5
WARNING: Operating unit without water can damage seals and void the warranty.
Always trigger gun until steady stream of water flows from nozzle to ensure unit is
receiving water correctly before starting the engine.
Step 5
Continue to squeeze gun
trigger until a steady stream
of water flows from nozzle
before releasing trigger.
Step 6
Start engine. Refer to the
Engine Owner's Manual.
Step 4
Release the gun safety-lock
and squeeze gun trigger.
Operating Instructions
WARNING: THE ENGINE IS SHIPPED WITHOUT OIL. Fill engine with the recommended oil to the
indicated level before operating the unit. Failure to do this will cause severe damage to the engine
and void the warranty. Please refer to the Engine Owner's Manual for details.
Step 2
Fill gas tank. Refer to the
Engine Owner's Manual.
Step 3
Connect the garden hose
to the water supply and
turn ON water full force.
Step 1
Check engine oil. Refer to
the Engine Owner's Manual.
Thermal Protection Valve
Your pressure washer is equipped with a thermal protection valve, located on the pump. If the engine
is left running for an extended time with the gun closed, the pressure washer will dump water into the
atmosphere through this valve.
NOTE: When beginning to spray, press the
gun trigger gently. Do NOT pump the trigger
rapidly between the ON and OFF setting.
CAUTION: Never allow the pressure washer to run for more than 3 minutes with the gun closed
and the engine running. Prolonged operation in bypass mode can result in damage to the pump.
NOTE: Always shut the engine OFF and engage
gun safety-lock when the pressure washer is not
in use. Refer to Shutdown Instructions on page 9.
To Next Page
Loading...
Need help?
General
