Kohler 20EKOZD - Page 59

TP-6953 7/19 59Section 2 Operation
Fault
Condition
Sensing
Mechanism
Fault
Condition
When
Active
Inhibit
Time
Time
Delay
Display
Cleared On
Intake air
temperature
ECM Engine specific.
Consult engine
specifications.
Running ECM ECM ECM
Fuel return
temperature
ECM
100_C
Running ECM ECM ECM
AC sensing loss Integral voltage
metering
No AC voltage at
controller
Running 10 sec. 3sec.
Alternator
protection
CTs and integral
metering
Exceeding alternator
protection curve
Running Crank Disconnect
ECM model
mismatch
CAN parameter file ECM comms don’t
match
Prior to crank
Run relay coil
overload
Internal hardware
and software
Relay coil exceeds
max. current
Running 0 0 Fault removal
and reset
Sensor supply
voltage
CAN (John Deere
only)
ECM Running ECM ECM
Starter relay
coil overload
Internal hardware
and software
Cranking Cranking
Figure 2 -21 Fault Parameter Default Table
2.9 Controller Parameters
The controller parameters list is an overview of the
various features and functions of the controller. Certain
features function only when optional accessories are
connected.
Note: Use Kohlerr SiteTecht softwareandapersonal
computer connected to the controller’s USB port
to configure the controller parameters. See
TP-6701, SiteTech Software Operation Manual,
for instructions.